Wolf Shaper

How to use

Parameters and controls

• Pre – Controls the input volume, before any processing has taken place.
• Wet – Determines the mix between the original and the processed signal in the output. Set this parameter at maximum value to only hear the processed signal.
• Post – Controls the output volume, after all processing has been done.
• Center – Removes DC offset from the output. This ensures that the resulting waveform is vertically centered at zero.
• Oversample – Sets the multiple of the sample rate at which the processing will be done. This allows the plugin to filter out some harmonics that would otherwise cause aliasing artifacts.
• Uni/Bi switch – Allows switching between symmetrical and asymmetrical waveshaping.
• Warp knobs - The two yellow knobs in the middle of the UI allow to bend the distortion curve dynamically. These knobs can be automated by the plugin host for interesting effects.
• Reset button – Puts the graph back at its default state, which is a straight diagonal line.

Graph editing

• Add a vertex – Right-click in the graph to add a vertex. Keep holding the right mouse button to position the vertex.
• Move a vertex – Left-click and drag the vertex.
• Remove a vertex – Double left-click on the vertex.
• Tweak the tension of an edge – Left-click and drag vertically the tension handle located at the center of the edge.
• Change the curve type - Right-click on a vertex, then select the curve type in the context menu.

User interface

• Resize the window – Left-click and drag the resize handle located at the bottom-right to resize the window.